0
Also you might want to check your oil to make sure it is up to the fill line. That will also stop the fuel pump from working.
A bad sensor will cause a no start problem because it sends a signal to the fuel pump if it is working properly and you have correct oil pressure. If it doesn't send the signal, no fuel will be pumped to the engine.
What else can I help you with?
How do you reset an oil sensor shut down on a dodge neon?
A Neon does not have a shutdown related to the oil sensor.
Why would there be oil in your camshaft sensor on a 1997 dodge neon?
Rear camshaft seal bad. Replace. located behind cam sensor.
What is the sensor behind the oil filter on a 1998 dodge neon how do you change it?
The sensor behind the oil filter for a 1998 Neon is a crankshaft position sensor. Unplug the wiring and remove the hold down bolt to replace it.
Does the neon have a low oil sensor that shuts the engine off?
No.
What is p0522 trouble code on dodge neon mean?
it is the oil pressure sensor. Check your oil level, then test your oil pressure sensor.
Where is the Crankshaft sensor position on a dodge neon?
the crankshaft sensor is above the oil filter on my 00 neon. it has one 10 mm bolt that needs taken out to remove the sensor
On your 2003 1500hd silverado when you turn on the key before you start the engine the oil needle pegs to 80 and says there even after you start the engine Is the oil sensor bad?
Most likely a bad oil sending unit
Where is the sensor 1995 neon?
There are several sensors on a 1995 Neon. The water temp sensor, crank shaft position sensor, and oil temp sensor are all mounted at various places on the engine block.
Will a bad oil sending unit on a 2005 Chrysler pt cruiser cause engine not to start?
No. The oil pressure sensor is not required for the engine to run.
Crankshaft sensor dodge neon?
It is located on the rear of the engine, just above the oil pan. It has a three wire sensor.
1997 Chevy Tahoe will not start. I have replaced the fuel pump and it turns over but still will not start.?
Possible bad crank sensor on the distributor, possible bad oil pressure swith.
How and why do crankshaft sensors go bad?
A crankshaft sensor can go bad if due to an oil leak. If oil breaches the sensor itself it will burn out.
