Want this question answered?
Legally, you must use the same brand breaker with the brand panel. They sell Murray breakers at your area electrical contractor shop, but used I am sure. However, square d homeline, siemens ite, GE, cutler hammer BR do fit but will void the UL listing and are dangerous to mix. Upgrade your panelboard. It is old.
A Murray or similar breaker would work but most inspectors want the brand breaker to match the brand panel.
In my experience, NOTHING is compatible with a Murray panel. Others claim there are certain Siemens and Federal Pacific breakers or Eaton type "CL", but you might have to obtain permission from the inspector to use anything other than Murray.
This is properly understood when Ohm's Law is applied: Voltage, Amperege and Resistance are correctly applied to a circuit for it's correct function. The circuit breaker acts as a protective device and trips when a correct electrical circuit does not exist. The wrong breaker may have been installed. the wrong gauge of wire may have been used, the pumps and heaters may be drawing more amps then planned for or a short circuit or loose connection are all possible faults. Contact the electrician that installed the system for resolution of the problem or an outside electrician if the problem isn't corrected. Caution: Water and Electricity should not be trusted when in close proximity.
The confluence of the Murray and Darling Rivers is at Wentworth, New South Wales
Legally, you must use the same brand breaker with the brand panel. They sell Murray breakers at your area electrical contractor shop, but used I am sure. However, square d homeline, siemens ite, GE, cutler hammer BR do fit but will void the UL listing and are dangerous to mix. Upgrade your panelboard. It is old.
A Murray or similar breaker would work but most inspectors want the brand breaker to match the brand panel.
In my experience, NOTHING is compatible with a Murray panel. Others claim there are certain Siemens and Federal Pacific breakers or Eaton type "CL", but you might have to obtain permission from the inspector to use anything other than Murray.
In my experience, NOTHING is compatible with a Murray panel. Others claim there are certain Siemens and Federal Pacific breakers or Eaton type "CL", but you might have to obtain permission from the inspector to use anything other than Murray.
No, they will not fit. You can use Westinghouse, Cutler Hammer BR series, and Connecticut Electrical UBITBC series breaker. All of those will fit.
The Murray River's nickname is the Mighty Murray.
no Murray is a river
No, they are brothers. Bryan is Bill's older brother
Murray Newey's birth name is Newey, Murray George.
Andy Murray is 30 years old (birthdate: May 15, 1987).
Norman Murray's birth name is Andrew Murray.
Bud Murray's birth name is Murray, Julian.