answersLogoWhite

0

yes,the only difference is the carb and the intake manifold.both engines have the same mounting]

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is a 3AU Toyota engine?

Toyota 3AU Engine specs


What is the horse power of Toyota 3au engine?

The Toyota 3AU engine is a 1.5-liter inline-four engine that typically produces around 80 to 90 horsepower, depending on the specific model and tuning. This engine was commonly used in various Toyota models during the late 1980s and early 1990s. Its design focuses on reliability and fuel efficiency rather than high performance.


What is valve tuppet clearance of 3au engine?

The valve tappet clearance for the Toyota 3AU engine is typically set at 0.15 mm (0.006 inches) for both intake and exhaust valves when the engine is cold. Proper clearance is crucial for optimal engine performance and to prevent valve damage. Always refer to the specific service manual for exact specifications and procedures.


Does the Toyota 3a-u motor have a cambelt?

Of course it has! it can also produce up to 7500 revs. the 3AU came up first before the 4AG, they are both use for Levin and trueno coupe version of Toyota, they also both use timing belt for their Over Head Cam, the only difference is that the 3AU only have single over head cam (SOHC) while the 4AG have double over head cam (DOHC) by the way, they also have a different power output becasue 3AU only have 8 valve while 4AG have 16, anyway, perfectly uned 3AU nowadays can still kick some butt.


How do you do a Carburetor adjustments on Toyota 3AU Engine to have a better performance?

In order to have a better performace with my engine I make sure that the fuel filter is always clean, and if trouble comes with my carburetor I clean it using gasoline and dried up using air compressor to remove some of the residue coming from the gasoline tank, In adjustment of the carburetor of my 3AU engine, the timing of the engien is important and the spark plugs are clean, and the distributor cup and cables are properly attached and clean, to have a better timing and adjustment of the air and gasoline required by the engine, if trouble comes just remove the air control to remove some dirt. while the engine is still running.


Can 4k carburetor will match 3au engine?

yes. very good result, high fuel efficiency without affecting the speed.


How many kilometer per liter does 3Au engine consumes?

If 4speed transmission it consumes around 9 to 11km/L But if you're using 5speed transmission it consumes around 12 to 15km/


How do you adjust 3AU carburetor?

To adjust a 3AU carburetor, first ensure the engine is warm and running smoothly. Start by setting the idle speed screw to achieve a steady idle, typically around 700-800 RPM. Next, adjust the mixture screw (usually located on the side) to obtain the best idle quality, turning it in until the engine stumbles, then out until it runs smoothly again. Finally, fine-tune both screws as needed for optimal performance.


How can you contact Alan Bennett?

By writing to his publisher, Faber & Faber Ltd, 3 Queen Square, London WCIN 3AU


What is the chemical formula for gold iii acetate?

The chemical formula for gold(III) acetate is Au(C2H3O2)3.


Is there any possible that 3au engine can fit in 5k gearbox?

Absolutely yes. only 5K gearbox has smaller clutch disk and 19teeth of main shaft, while T50 and T40 gearbox had larger clutch disk diameter and has 20teeth main shaft, as far as all concern, bellhousing will fit perfectly


What bank has sort code 30-99-93?

Lloyds TSB 41-43 South Street, Town Centre, Worthing BN11 3AU 0845 300 0000