Not easily. The 940 engine is a 4 cylinder rear wheel drive that is oriented front to back. The 850 engine is a transverse 5 cylinder front wheel drive. The transmission/transaxle in the two are very different.
the 940 is six cylinder..850 five.
The diesel turbo can only fit on a Volvo 850 with a little fabrication.
yes they are identical cars but you must do a complete swap (engine ECU as well) Kyle
Yes. The 740 and 940 are very similar and share many common parts.
The seats from a Volvo 850 will not be able to properly fit into a Volve s40. This is because the vehicles have different body types and do not mesh with one another.
BOTH - 21" (inches)
If you have a Volvo roiginal radio, it is likely to be produced by Alpine. Depending on your radio, different Alpine changers may fit.
Yes. However it's not that easy due to the turbo versions electronics (if it's a 700 series turbo your after). But fully possible and has been done several times.
1999-2003 Hyundai Elantra I have one in my 1994 Volvo 850 turbo wagon, i had to take of one of the screws holding the wire down to the battery holder, and it had enough clearance to fit with room for play, and all the rest of the battery fits in the grooves of my battery holder so i would recommend this battery for a 94 Volvo 850 turbo because it was one of the highest CCA and the higher it is i no the more they hold but anyways its better for the cold starts in the winter if your from new England like me. the one for my car was like 500 CCA, then i saw this one with 850 CCA or w/e it says, so i got this one.
YES THE DOORS OF 740'S AND 940'S ARE THE SAME, THE ONLY DIFERENCE RESIDE INTHE WINDOW PLUG WHICH IS DIFERENT BETWEEN YEARS, SO USE THE SAME YEARDONOR CAR OR JUST CUT THE HARNES AND CHANGE IT WITH THE ONE FROM YOUR CAR, THE 2 WIRES ARE THE SAME. GOOD LUCK.
Transmission fluid is added through the transmission dipstick. Suggest you get a long thin funnel with a small opening in order to fit into the dipstick opening
Not without custom modification. The radio opening is only a single DIN, and any dash kit will be made for that opening.
Try to find a Volvo or Saab but you'd have to make your own flanges.