A faulty slave cylinder will not cause your clutch to slip. The slave cylinder is made up of a housing and a rod. The rod pushes the throwout lever against the throwout bearing, that push the teeth on the clutch housing causing the clutch to disengage and you are allowed to shift the gears.
When a slave cylinder fails it makes it difficult for you to shift gears. When it completely fails you will not be able to change gears at all for the most part. I sincerely hope this helps you.
www.subarushirt.com The only exception would be if the slave cylinder managed to leak fluid onto the clutch disc.
This is a hydraulic master and slave cylinder clutch, there is no adjustment. Check for a leak in the system, a faulty master or slave cylinder, or wear on the clutch plate.
The slave cylinder has failed and will need replaced.
If we are talking about a clutch slave cylinder for a standard transmission, yes it could.
It's a self adjusting hydraulic clutch. If it needs adjustment, it's probably either a bad clutch or a faulty clutch master or slave cylinder.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
The clutch slave cylinder , for a hydraulic clutch , is inside the manual transmission bellhousing
The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing
The master clutch cylinder is attached to the clutch pedal. When one depresses the pedal hydraulic fluid is forced from the master cylinder through the hard line to the slave cylinder. The piston in the slave cylinder is driven against the clutch linkage thereby releasing the clutch.
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
In cylinder
The clutch master cylinder is in the engine compartment and the slave cylinder for the hydraulic clutch is inside the manual transmission bellhousing
The clutch pedal assembly has a clutch rod that pushes in on a clutch master cylinder. There is a hydro line that goes from the master cylinder to the slave cylinder.