answersLogoWhite

0

yes. I'm not sure if the speed sensors for the ABS are located at the wheels or in the diff though. if they're at the wheels then you may be able to remove them from the old axle and attach them to the new, "non-ABS", axle and make it an ABS system.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Vacuum lines to front axel on 1995 Jeep Wrangler?

diagram from front vacuum motor to transfer case of 1993 Jeep Wrangler


Will a 1993 Jeep Wrangler power steering work in a 1989 Jeep Wrangler?

They are both YJ's so it should be a good fit.


Will a 1993 Jeep Cherokee front end fit a 1993 jeep wrangler?

no, they are entirely different vehicles


Where is the gas tank located on a 1993 Jeep Wrangler?

The gas tank on a 1993 Jeep Wrangler is under the very rear of the vehicle. It is just in front of the rear bumper.


What kind of axles does a 1993 Wrangler YJ have front and rear?

dana 30 front dana 35 rear


What size are the front speakers in a 1993 jeep wrangler?

the stock speakers are 4x6 inches


Where is the jack located on 1993 Jeep Wrangler?

YJ jacks were located in the engine compartment, front of the battery


Will a hard top from a 1993 Jeep Wrangler fit a 1997 Jeep Wrangler Sahara?

Not without major modification, the YJ top is different than the TJ top


How do you remove the front speakers in a 1993 jeep wrangler Sahara?

think you take the plastic covering off and undo the wires and unbolt it


Wrangler 1998 dash board fit into wrangler 1993?

No, they are different


Where is the OBD1 connector on a 4.0 1993 Jeep Wrangler?

The 1993 Jeep Wrangler as are all modern vehicles is equipped with the on board diagnostic system and access port. The OBD Series I connector port will be located on the right front side of the vehicle below the steering wheel.


Where is the Jeep Wrangler slave cylinder?

how to replace the slave cylinder on a 1993 jeep wrangler