No it will not the 97 is a third generation and the 93 is a second generation Escort.
how do you take off drivers side axle- 93 escort wagon? Kevin
check your answer
any front end off of a vw type 1-3 should work good
ford escort mk1 has a vin number on off side front strut top and a tag on the slam panel.
Jack the front end up and place it on stands. Don't trust a jack. Take the wheel off. Disconnect the hydraulic brake line and plug it. take the 2 caliper bolts off. Spread the caliper by inserting a screwdriver between the rotor and the caliper piston. Slide the caliper off pull out the pads. Put new pads in with the new rotors.
Its not gonna bolt up,but anything can go any car,just have to make it work..If people are puttin Benz fronts on a f150 and beamer front ends on an escort,you can put a 2g front on your 1g eclipse.gonna be work,there wider cars then the 2g,might have to put a extension in the front bumper,makin it wider... Jay East Coast Customs
The front end of a ship or boat, the end that usually comes to a point, is called the bow, pronounced bough. The other end is called the stern.
In a 1998 Ford Escort ( sedan or wagon ) The fuel pump shut off switch ( inertia switch ) is located in the drivers footwell behind the kick panel ( there is an access hole through the panel ) * the kick panel is the interior trim panel , in front of the front door , beside the drivers left foot
most of the ecm on the 1997-1999 escort is on the floor right in front of the stick there are panels on both sides that come off pretty easy and you will be able to see it right in the middle hope this helps
Remove the wheel and tire assembly and the brake caliper then the brake rotor will slide right off.
Buy a shop Manuel and will tell you step by step on how to do it.you can find this at AutoZone or advance auto
The timing belt is located behind the timing cover on the front of the engine as you are looking at it from the passenger side front fender. The serpentine belt has to come off to get to it.