0
Will a model 7 drop floor plate and trigger guard fit a rem600 mohawk?
Wiki User
∙ 14y ago
No
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will a model 7 stock fit a 600 mohawk?
A model 7 stock would not fit a 600 Mohawk. The stock and the trigger guard do not line up correctly, although the stock may fit on the gun.
Where can you find a trigger guard for a savage arms model 6d?
The trigger guard is available from Numrich Gun Parts. There are two different types of trigger guards for the Savage 6d. The plastic guard that has a inletted area for the trigger guard in the stock and the simple bent metal trigger guard that just screws into the stock wood. Plastic trigger guard is product # 103530U $24.10 Metal guard is product # 10543OAL $11.50
Can you put a double trigger on a basic Tippmann A5?
Yes, just simply buy a double trigger and double trigger guard, open up your marker, remove and replace the old trigger and trigger guard.
Where is the safety on a 520 shotgun?
It is a lever inside the trigger guard, forward of the trigger.
How do you install trigger guard on harrington richardson topper shotgun?
Installing trigger guard in H&R Topper 88 single shot shotgun. I am not a professional gunsmith, so your mileage may vary, but this is how I _finally_ got it done. 1. The "trigger extension, the trigger, and the trigger guard have to all line up together, and line up with the pin holes in the receiver when the pin is inserted. It is next to impossible to get them to line up, and keep them lined up. Before in inserted the trigger guard into the receiver, I lined up the trigger, trigger extension, and trigger guard holes. Then I inserted two small splinters of wood from either side as shims and pushed them in tight until the holes stayed lined up. I cut the splinters off even with the outside of the trigger guard. After I inserted the trigger guard in the receiver, I got the trigger guard lined up with the pin hole in the receiver, then I hammered the pin through and drove out the wedges. 2. There are two opposing springs that fit in holes in the trigger guard. The rear one goes to the trigger. The front spring goes to the barrel break release. Leave the front spring out to start. Then after you get the trigger guard back in, you can hold the barrel break release up and drop the front of the trigger guard down just enough to insert the spring through from the front of the receiver.
Does a 1872 colt 45 have a serial number?
yes. bottom of grip. front part of trigger guard and on frame in front of trigger guard...........
How do you remove and replace a Harrington and richardson topper m48 trigger guard?
how to remove and replace trigger guard on Harrington Richardson topper shotgun n
How do you use the word ' trigger' in a sentence?
Example sentence - The gun had a trigger guard on it for safety reasons.
How do you get the trigger and trigger guard off of a nepalese 1851 enfield rifle?
Best to ask a gunsmith for assistance.
Where can you buy a trigger guard for a JC Higgins 101.7 shotgun?
Made by Savage/Stevens. We have trigger guards.
How can you adjust the trigger guard on a spr 100.The break lever sticks out behind the trigger guard This causes some really sore middle fingers.?
A good gunsmith can help you out.
Who has a trigger guard for a Springfield 22?
Try e-gunparts.com
