Yes it will fit.
The 350 sbc was introduced in the new for 1967 Chevrolet Camaro , it was rated at 295 hp .
It will hold 5 QTS. with a new filter.
if your caprice has a 305 or 350 already there shouldn't be a problem. otherwise new or custom motor mounts will be needed, also a tranny to match up to the 350 from the camaro
yes it will on Chevy the bell housings are all the same as long as it is a rear wheel drive you may want to get the motor mounts from the car that had the 350 for your new car. *** its a huge pain. You have to drop the motor from the bottom of the car.***
have the cylinders bored .030" oversize and fit it with new pistons.
i believe the chevy 350 fits, but you will have to do a lot of new wiring.
Yes. They will bolt on any small block, prior to 89. However, hedders are made for the car. Camaro, Chevelle, pick ups, ect. If you are just swapping motors fine, but, if you do not know what the hedders came off of, then they may not fit your car, and will hamper your steering, and have other clearance issues. Don't try it. A new set is only $100, or so.
Yes it will.I put a hood from an 86 put on my 91 RS and it fit perfect. I later dumped it for a new 89 Z28 hood cause the 86 hood was not cherry.
Click on the link to your right for the answer.
yes well it depends did the 86 have a v8 before? if so it will go right in? if not you will have to buy new moter mounts i belive but yes it will fit just fine
Don't put a buick engine in a camaro. Instead, get a 350 LT1 (GM - corvette engine) for about 200 bucks used or 800 new. Sell the lesabre for this engine if you need to.
Ann Benson