Want this question answered?
The previous answer to this question was "use a high pressure power washer". I must say that depending on the type of brick, state of the mortar and condition of the brick itself, using a pressure water could cause nothing but problems. Some bricks and all mortar are porous. Using high pressure water will do nothing but force water deep into the mortar joints and the bricks themselves. Getting the paint off without damaging the bricks is not an easy task. Using a stiff bristle (not metal bristles) and warm water with dishwashing soap is the first thing to try. After that you can try one of the gel pain strippers or a heat gun and gentle scraping. The most important thing is protecting the integrity of the brick. You can always redo the mortar in certain areas if you damage it, but you don't want to have to replace bricks. Sandblasting will remove the outer "coating" of many bricks exposing the porous internal brick...not good. If you do have to deal with mortar and tuckpointing and your brick/mortar is more than 90 years old you cannot use modern "portland cement" mortar. It's too hard and will ruin the older, softer bricks. There is a lot of info on mortar and old brick. Never ever use a portland cement product on older brick and never use a high pressure washer or sandblast a brick wall of any age.
You can use a power washer to clean aluminum pontoons. The power washer will remove most of the dirt. To remove additional discoloration you can use a product such as Barkeepers friend.
you can use a power washer
A power sprayer with water should do the trick.
A power washer and carpet cleaner is the best way to remove dirt from patio furniture fabrics. The fabric is a tougher grade so that it can undergo the outside weather. A power washer will remove a large amount of the dirt.
Power supplies can be found online as well as a brick mortar store. Everywhere from Best Buy to Home Depot to your local hardware would be great places to find a power supply.
Quickest, cheapest and easiest is to use a power washer.
I recommend a power washer and a fungicidal solution. If that fails, there's always sandpaper.
You need to remove the washer fluid. You can siphon it out, or remove the power steering reservoir and dump it out. If you haven't had the car running , you may be able to absorb it out with a rag since it is probably floating on top of the power steering fluid. The problem with washer fluid is that it is not compressible and will cause poor steering reaction when it enters the steering pump. It may even cause a loss of steering.
A power brick is a red Lego brick hidden in each level. They unlock extras to buy
Jack Lalanne Power Juicer can be purchased wherever small kitchen appliances are sold such as Bed Bath & Beyond, Sears, Target, Kohls and other brick-and-mortar retailers.
No. They are very different.