0
What else can I help you with?
What is double pulley system?
A double pulley system is simple. Instead of one wheel like the single pulley system has, the double pulley system has two wheels and carries more heavier loads than the single pulley system can hold.
How do you put on a water pump pulley for the serpentine belt on a 1995 Chevy Lumina minivan?
there should be 3 or 4 bolts that hold pulley on, just remove these bolts a pulley should come off. but remove belt first ! if pulley keeps turning while removing bolts. you can hold it stationary with a scredriver or similar.
How do you repair a crankshaft pulley for a 98 Saturn SC2 DOHC?
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
How much weight can a pulley hold?
The amount of weight a pulley can hold depends on its design, materials, and construction. Typically, pulleys are rated to hold loads ranging from a few pounds to several tons. It is important to check the manufacturer's specifications to ensure that a pulley is being used within its weight capacity to prevent damage or failure.
How do you pull a damper pulley from a Chevy 350?
If you are just removing the pulley, Then just remove the bolts that hold it on being sure to remove the bolt that is in the middle of the pulley too. Then take a hammer and knock it off.
What are idler pulleys?
== == it is a free pulley that works as a tensioner on any belt bolted to hold or spring loaded An idler pulley usually tensions a belt.. eg supercharger belt is kept taut by its respective idler pulley
How do you remove power steer in pump on factory no air Chevy?
You have to remove the pulley first and you need a power steering pulley puller to do it. You can get one from Napa for usually about $40. There are bolts behind the pulley that hold the pump to the mounting bracket.
How do I change the blade on my Toro riding mower I followed the manual which says to hold the blade and remove the bolt -- I have done that and the pulley turns -- do I have to hold the pulled too?
THE BOLT MAY HAVE LEFT HANDED THREADS...HAVE YOU TRIED TURNING THE OPPOSITE DIRECTION? The bolt is threaded into the same shaft that the pulley is attached to. Once you get the bolt loose enough that it starts to come off of the shaft you may have to hold the pulley to finish removing it.
How do you replace water pump on Chevy impala 2004?
To remove the water pump, first, make sure engine is cool and no pressure in the system, remove the belt. Then hold the pump pulley tightly and remove the 4 10mm bolts that hold on the pulley. Tap the pulley to remove. Then remove the 5 5/16 (or 8mm) bolts that hold the pump. Be sure a drain pan is under the car to catch the coolant. Clean the mounting surface of old gaskets. Install new pump, pulley, belt, and bleed the system
What is a double movable pulley?
A double pulley system is simple. Instead of one wheel like the single pulley system has, the double pulley system has two wheels and carries more heavier loads than the single pulley system can hold.
Is a flag pole a pulley?
No, a flag pole is not a pulley. A flag pole is a stationary upright structure used to hold a flag, while a pulley is a wheel with a groove used to guide a rope or chain in order to lift or move objects.
How do you take off crankshaft pulley on 2 liter diesel year 2001 without the engine turning?
Use a strap wrench or chain wrench on the pulley to hold it secure.
