Possibly. Depends on which model Siemens breaker you have.
No, a Cutler Hammer will not work in a GE panel or vice versa.
No, they will not work. Use only Murray breakers for safety.
It depends on the specific style of the breaker. Bring your T&B breaker to a hardware store or Home Depot and check with the people in the electric department. Many are now interchangeable with ITE, GE and Square D. However, older T&B breakers are not interchangeable.
For Si it is 0.6or 0.7 and for Ge 0.3 or 0.2.Both values correct for both si and ge
Ge has higher conductivity than Si. Because at room temperature the electron and hole mobility for Ge is larger than those of Si. Another explanation is the lower band gap of Ge than Si.
No, a Cutler Hammer will not work in a GE panel or vice versa.
No, a Cutler Hammer will not work in a GE panel or vice versa.
GE or Siemens cutler hammer universal CL series
Yes, some can work in other panels. But you go to an electrical supplier and get the one that is the brand of the panel. If it is old and you can't find it, then try a GE breaker.
It probably wont fit. But if it does there should be no other reason why it wouldn't work.
Yes, as long as the lug connects to the panel thye same way.
A GE tandem breaker can be removed and replaced with a GE single pole breaker.
Only if the form factor and specifications are the same. Usually, if it fits and mates with the panel and is the right current and voltage rating, you are okay.
Cutler - Hammer manufactures two types of residential circuit breaker for the US. Type CH and type BR. The type BR will fit into most GE panels. It is probably a bad idea to use any other circuit breaker except the type listed on the label of the circuit breaker panel. GE panels require you to use GE circuit breakers. Using any other brand may put you at risk for liability if the installation fails and causes harm or damage.
Legally, you must use the same brand breaker with the brand panel. They sell Murray breakers at your area electrical contractor shop, but used I am sure. However, square d homeline, siemens ite, GE, cutler hammer BR do fit but will void the UL listing and are dangerous to mix. Upgrade your panelboard. It is old.
There are many ways one can install ge circuit breakers. One can install ge circuit breakers by turning off the power supply, removing the panel cover, testing it for power, and installing it by alining the breaker with the unused panel space.
Breakers are build to snap onto a buss bar in a breaker panel. If they look the same on the back end then they will likely work. If not do not try to force a fit. To add a little more to this: 1st of all it depends on what kind of Square D you are talking about. Square D Homline breakers will fit in a GE panel but GE breakers will not fit into a Homeline panel in my experience. Square D QO is not compatible with either.