Usually when a starter solenoid/relay switch is bad, you will hear only a click and the starter will not spin (crank).
For any gasoline engine to start it has to have fuel. Check to see if your getting gas in the carb. You may just need a fuel pump.
If the Chrysler Sebring won't start after going through a puddle, the problem is probably that the starter relay switch got wet. This is not a common thing but if the starter relay was bad to begin with, moisture will make the problem worse. The starter relay is located on the starter.
The starter relay is integrated into the starter. Have you checked the neutral lockout switch? If the neutral lockout switch is faulty or adjusted wrong the starter will never engage. It could also be that the starter wires are cross-connected. Using a volt meter, make sure you are getting voltage to the starter bendix when you attempt to start the engine. If not, start backtracking to the keyswitch to see where you DO have voltage.
Check your ingnition cylinder ...
By passkey. If you are talking about a starter by-pass. It is not keyed, but a push button on & off switch. You must break the small wire at the starter relay, or solenoid, and wire the switch in series. After the car starts, you must release the push on/off switch, or you will keep turning the starter motor.
might be starter relay, or the crank circuitry from the switch or to the starter from the relay. I would trace back from the starter to the starter relay back through the neutral safety switch to the ignition switch.
The starter relay feeds power to the starter when the switch is turned to start. The relay will be mounted either on the fender or on the firewall.
The starter relay on a 1992 Pathfinder is mounted between the transmission and engine block. The starter uses a gear drive to crank the engine and help it start.
That's the starter relay. Replace the starter.
i had the same problem with mine. its the soleniod.
Where is the starter relay switch in a 1995 Nissan Quest? We were told it could either be the relay switch or the starter, because when we start our van and drive it and then turn it off, it will not start again for at least 5 hours. It does this almost every time we drive it. We have had the key/ignition tumbler replaced in it twice in the last four months.
Where is the starter relay switch on a 94 Corsica V6 yam
For any gasoline engine to start it has to have fuel. Check to see if your getting gas in the carb. You may just need a fuel pump.
A single click when trying to start the engine is usually an indication of a loose battery cable/wire or a faulty starter solenoid/relay switch.
-Starter shot -Starter Relay is bad. -Crank Position Sensor is bad? There are more possibilities.
Unless there is an aftermarket hard start relay installed on the car, there shouldn't be one. The starter is attached directly to the ignition switch and the battery.
If the Chrysler Sebring won't start after going through a puddle, the problem is probably that the starter relay switch got wet. This is not a common thing but if the starter relay was bad to begin with, moisture will make the problem worse. The starter relay is located on the starter.