Want this question answered?
No, they will need replaced if defective.
Jim rice from sinclareville ny say soak it in used motor oil then stick it back in..
Ammonia factories do not clean your cells or do anything else for that matter.
As far as I know they can not be cleaned. Must be replaced.
Well, you see... you put it on the mess and it cleans it. And that is how ammonia cleans.
yes it can
No, O2 sensors are to clean up the emissions. If you have a gas smell, I would suspect fuel lines, or a gas cap.
O2 sensors are located on the exhaust system in todays vehicles, they monitor the oxygen levels in the engines exhaust gases. They send that information to the vehicles computer which inturn regulates the engine's fuel system for a clean burn.
NH3 is made by N2 and H2. pure NH3 is clean ammonia.
Household ammonia is a solution of ammonia in water. Mostly it is used to clean household utensils.
No, they must be replaced when they wear out. Sure. Pull it out, clean the end with a wire wheel or brush and re-install. O2 sensors don't usually fail, they just get dirty.
They actually sell special cleaners for the use to clean silicon. It is not recommended to use any other type of generic cleaner to clean silicon due to the possibility you may ruin it or cause damage.