Want this question answered?
there is an instrument called lux meter. i believe that it works with a complex electronics circuitry using light sensitive devices. it directly gives the reading in lux.
Batteries are a voltage storage device that hold a voltage potential until used. By using a volt meter you can find the stored voltage by placing the leads of the meter across the battery's positive and negative terminals.
You can measure directly with an Ohm Meter, often combined with a Volt Meter. Or you can measure the voltage across the resistance and the current to calculate resistance as Current divided by Voltage.
Deformation is calculated by using deflecto meter.
None.AnswerIt depends! A capacitor is an open circuit, yet a.c. current flows quite readily. And d.c. current will flow for a very short period of time.
If you are referring to using a volt meter then you will just get a negative reading on most modern digital meters. If you are using an old analogue meter you may get no reading.
In a DC circuit, just connect your meter across the source or electrical bus. The meter, because it is one of the newer digital ones, will work regardless of which way the leads are connected. If the leads are plugged into the meter correctly, the investigator need only look at the sign associated with the reading on the meter and the position of the leads. If the reading on the meter is "13.6 V" on a DC setting, then the red lead is connected to the positive side or negative rail, and the black to the negative side or negative rail. Conversely, if the reading is "-13.6 V" on a DC setting, the red lead is on the negative side or negative rail, and the black lead is on the positive side or positive rail. The DMM is a wonderful innovation and will allow someone making measurements to not have to worry about which way to connect the leads - as long as that someone pays attention to the sign displayed with the voltage reading.
Nutral wire can be measured by using clamp meter, if there is a current passing through the wire, we got a reading in the clamp meter i.e. 2A. If we clamp the earth wire by the clamp meter the reading will be zero.
Using a Direct or Incidence reading Light Meter.
Does wiki answers have you an orgasm?
Too many variables, need more data.
You can't. Only time will help and remember that using hand sanitizers, mouthwash and other products with any type of alcohol will cause the test to give a positive result (the presence of alcohol).
Yes to a degree. Too much of it will actually get you drunk.
pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.
you can calculate a meter by using maybe a meter stick or a tape measure...
there is an instrument called lux meter. i believe that it works with a complex electronics circuitry using light sensitive devices. it directly gives the reading in lux.
No NEETs are counted using positive integers.No NEETs are counted using positive integers.No NEETs are counted using positive integers.No NEETs are counted using positive integers.