answersLogoWhite

0

It can, but not always.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you stop a 2000 Pontiac Montana SE from idling fast after starting it?

replace the cam sensor


Will a speed sensor in a 1998 dodge neon stop the car from starting?

Crank and cam sensors, yes. Vehicle speed sensor, no.


1996 Dodge Intrepid stalls when i am coming to a stop and i try and take off.changed fuel filterstill stalls?

Try the crank sensor first, then the cam sensor. without these the car will not spark. Most commonly the crank sensor though.


Cam position sensor location for 1996 Dodge Intrepid?

Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!


Where does the 2003 Dodge Intrepid cam positioning sensor is located?

Front driver side of engine.


What would make a Intrepid shut down?

Cam sensor. Changed mine no more problems.


Does a cam-sensor on a 2000 Daewoo Leganza will stop the car from starting?

cmp snsr will not prevent the car from starting,ckp snsr would.


How much does a cam sensor for a dodge intrepid cost?

I just bought one for a 1997 3.5 for 35


Where is the crankshaft sensor on a 2002 Dodge Intrepid?

if its the 3.5L the sensor is right on top, at the front of the engine. the cam sensor is near it just to the driver side of the top of the engine. The intake has to be loosened enough to get the cam sensor out form under it. The crank sensor is easier to get out.


Will a bad cam sensor stop your 1997 dodge avenger 2.0 from starting?

It could, along with numerous other things.


Can the crankshaft position sensor cause the car not to start?

yes this will stop car from starting. a bad cam sensor will also stall engine at any speed.the sensor is easy to replace.


Will not crank no fire codes OK coil OK 96 Dodge Intrepid 3.5 what to mlook for?

try crank position sensor and cam shaft sensor