0
Current goes path of least resistance. But if u have two resistances in paralell only the majority will go through the smaller resistance some Porportional Amount will "flow" through the larger resistor. Depends on resistance sizes and voltage slap plied as to how much current
What else can I help you with?
What current will travel along the path with the highest resistance?
In a circuit, current prefers to flow through paths with lower resistance according to Ohm's Law (I = V/R). However, if there are multiple parallel paths, the current will split, and the path with the highest resistance will have the least current flowing through it. Therefore, while current does not travel along the path with the highest resistance, it will still exist in that path, albeit in a minimal amount compared to lower-resistance paths.
What path do electricity travel along?
Lowest resistance.
Does current depends on its resistance?
The current flow in an electrical circuit depends on the applied electromotive force (EMF, measured in volts), and the total resistance along the entire circuit. Rising EMF or dropping resistance cause increased current flow
What determines the flow of electricity along the path of least resistance?
Electricity flows along the path of least resistance due to Ohm's Law, which states that current will follow the path with the least resistance. This means that the flow of electricity is determined by the resistance of the material through which it is passing.
What does the slope of voltage-current curve represent?
It depends. If voltage is drawn along the horizontal axis, then the slope at any point on the graph represents the reciprocal of resistance at that point. If current is drawn along the horizontal axis, then the slope at any point on the graph represents the resistance at that point.
Reducing the current you a circuit causes what?
Reducing the current to a circuit causes a higher resistance -- assuming constant Volts. Also, reducing the current to a circuit causes lower Volts -- assuming constant resistance.AnswerAltering the current has absolutely no effect on a circuit's resistance. Reducing the current will reduce line losses (I2R) and reduce the voltage drop along a conductor.
What large surface current runs along the east coast of the United States and what direction does it travel?
Coriolis effect
Why do you always speak about voltage drop and not current?
Voltage is like the pressure in your hose pipe. Current is the flow of charge and equivalent to the rate of flow of the water. Due to resistance to the water in the pipe,the pressure of the water will reduce along the length of the pipe but the quantity of litres flowing in the pipe will not change. So voltage will be maximum at the source of the voltage but as you move along the conductor there is voltage drop due to the resistance of the conductor.However, the current is same at all points along the conductor (the flow of charge is uniform at all points)
Why resistance drop occurs in a conductor?
All conductors have some amount of resistance associated with them. There is voltage drop along the length of a conductor because the potential energy of the voltage is lost to heat losses (I^2 *R) due to this resistance. The more resistance, the more voltage drop. The current is set at a given voltage and power level.
How does a rheostat work?
A rheostat is simply a variable resistor. It is engineered so a "wiper" travels along the resistor carbon path. There is minimum resistance at one end of the path, and maximum resistance (what maximum value the engineers made into it) at the other end. Rheostats come in many values such as "0 to 1000 ohm", 0-1000 ohm, 0-10,000 ohm, and etc., all the way up to mega-ohm values. Some are designed to work on 0-5 watts, 0-20 watts, or larger power versions with resistance wire in them.
Why are two wires used to allow electric current to flow instead of a single one?
Because the current must always travel in a complete loop, going through the circuit and returning to the supply. A current can't travel along only one wire so no power would get to the circuit unless it has two wires.
What instrument used to measure alternating current?
A multimeter has the ability to measure both AC and DC current along with voltage and resistance.
