Not exactly "damage", but if you keep it on the charger all the time,
then the battery capacity may appear to decrease, i.e., the battery
won't last as long when you do use it. Think of the battery as a muscle.
In an uninterrupted power supply there has to be a source of power when the electrical utility is not there. The only supply that is available is a battery that is in or connected to the UPS.
Yes it will damage the power and have less battery life.
TRY THIS: Open the tape door on the bottom. LEAVE IT OPEN. Power off your camcorder and remove the battery. With the battery removed, move the power switch to ON. LEAVING THE POWER ON AND THE TAPE DOOR OPEN, replace the battery. The tape should eject without damage. This works for many other models as well.
A battery-operated smoke detector is one which is not connected to your homes power supply.
If the battery was connected backwards even for a split second it is likely it has blown all the main power supply fuses. It may also have other damage. But the fuses is the first thing
No set answer to that. It depends on the capacity of the battery and the power consumption of what it's connected to.
No. The power commander requires power to send the relevant information to the throttle bodies. If the positive lead to the battery is not connected, or connected incorrectly, then the engine will turn over but it wont fire up.
battery
If the battery of your MacBook is fully charged whilst you have the power cable plugged in, then the MacBook will switch to battery power instead of wasting electrical power from the plug. Once the battery is run down again, the Macbook will switch back to electrical power from the plug.
Sure you can. But it would be much easier to purchase a compacitor which acts like a battery in that it stores power and uses that to power what is connected to it. This also saves the alternator
If your battery is dead and you connect the power supply with your battery installed, the battery will automatically start charging. If you wish to run your MacBook off your power supply only, simply remove your battery from your MacBook and connect the power supply. You will then be running solely on the power supply. If you battery becomes fully charged while your power supply is connected, you MacBook will switch to the power connector as it's power source - preserving the battery.
Chemical energy is stored in a battery. When the battery is connected in a circuit, the chemical energy is converted into electrical energy which can power devices.