answersLogoWhite

0

Yes, most likely. If your speakers are rated for 140w each then it's possible to blow them if your amp drives em at full power. If you do hook them up then find a way to limit the volume or output of your amp. Sophisticated amps and stereos have settings that allow you to do this.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Will 20W speakers work with a 10W amplifier?

They'll work, but could blow.


Can you blow out your speakers if you use the wrong power amplifier?

Speakers can be blown if the wrong power amplifier is used and damage can be done by either overpowering or underpowering the amp. For example, if the power rating of the speaker is 300 watts capacity you will need a 300- to 600-watt amp.


Can you run 4 70w speakers on a 150w amp or will it blow?

It's entirely possible to use four 70W speakers with a 150W amplifier but the method will depend on the speakers and the amplifier specification. We will assume that the amplifier will deliver up to 150W per channel, so two speakers will be used on each channel. If the amplifier is rated to drive a 4 ohm load, then two 8 ohm speakers can be wired in parallel and connected. In this instance, take care NOT to drive the amplifier too hard. It will overdrive the speakers at about the same time that it will begin to show a distorted output. This is a condition that can easily damage speakers so be very conservative with the volume control. If the speakers are 4 ohm speakers, they can be wired in series to provide a total impedance of 8 ohms. If the amplifier is rated to deliver 150W into 4 ohms, then the total power to the speakers will be lower than to a single speaker. The benefit is that no speaker can be over-driven and there is a good amount of headroom for safety.


When was Blow Your Speakers created?

Blow Your Speakers was created in 1987.


Can you play a bass guitar through a tube amplifier?

Years ago all we had was tube amplifiers. As long as its a bass amp (so you don't blow out the speakers) there is no problem.


What is the best way to wire your subs to get the most power?

You get more power by wiring the speakers in parallel, but you need to verify that the amplifier can handle that configuration or you may blow the amp.


Can a 15 watt amplifier power 300 watt speakers?

Yes it can. The rated power of the speakers is the MAXIMUM that can be applied. If more power is supplied, damage can occur. Either the speech coil can blow or mechanical damage to the cone or suspension units.As the amplifier is below this rating, it will not supply more power than the speakers can handle and will be perfectly safe.


Can you plug an amplifier in to an LCD TV via the headphone port on the LCD. will it blow. i have a jvc amplifier with two Bose speakers i want to use them on the LCD?

Plug the audio system into the AUDIO OUTPUT jacks on the LCD. Go into the menu and change the signal to the jacks to FIXED if you can.


Your amplifier is 150Watts your speakers is 30Watts each for 4 pieces it will work?

You may have 1500 watts output but the speakers will only dissipate 30watts each the answer yes they will work fine as long as you do not increase the level whereby the speakers will have to dissipate 1500 watts because they will blow open with the extra output demand.


What is the Song Revolution by Chris Deburgh about?

His new song his Blow your speakers up scream it out loud Blow your speakers up get in with the crowd Blow your speakers up party all night Blow your speakers up get in with the crowd We gonna party till we drop party rap


Does incorrectly installing speakers damage your engine?

Probably not. You will either blow a fuse or blow your speakers before you do any damage to the electrical system in your car.


What is the meaning too the song Ugly by The Exies?

Blow your speakers up scream it out loud Blow your speakers up let in with the crowd Blow your speakers up party all night Blow your speakers up get in with the crowd Were gonna party till we drop rap