Not likely. The transmissions are different. If you own a 1990, you can use parts from 88 to (I think I remember this correctly) 92.
No you can't.
Under rear, in front of back axle.
there are axle shafts on the left and right fronts.there are axle shafts on the left and right fronts.
It might not have been torqued properly.
Assuming you mean the front axle 4WD actuator, it is on the passenger side of the front axle housing.
bent drive axle or axles
step one is the check lug nuts ----------- step 2 is the axle busted grease around axle
Axle shaft u joint or the steering knuckle.
1 1/4 inch
On a 4 speed transmission it is the output speed sensor. That ir the sensor on the front of the trans farthest to the driver side. On a 3speed transmission it is on the housing that the passenger axle shaft comes out of trans in.
It is on the back of the trans, where the passenger side axle goes in.
Back of the trans, in the housing that the passenger axle goes into.