It could, The "bus" is the communication system between the computers. If you have theft or chipped keys it could cause a no start or no crank if the computers are not able to "talk" to each other to pass along the ok to start message.
It could, The "bus" is the communication system between the computers. If you have theft or chipped keys it could cause a no start or no crank if the computers are not able to "talk" to each other to pass along the ok to start message.
It could, The "bus" is the communication system between the computers. If you have theft or chipped keys it could cause a no start or no crank if the computers are not able to "talk" to each other to pass along the ok to start message.
To reset the engine light on a Toyota Prius, disconnect the negative battery cable and let off for about five minutes, then reconnect it. The light should go off after the first couple start ups.
Pull out the engine and let the kids push... you drift.
Try disconnecting the battery terminals and let sit for a minute or two. Then reconnect and start vehicle! This should reset the computer and the check engine light should be off! If this does not work try disconnecting again and let sit for a longer period of time!
Turn the key on, DO NOT START ENGINE. Push the gas pedal all the way to the floor 3 times and let all the way off each time. Then turn key off and then start engine.
you have a diesel warming light on the dashboard display near the speedo,in the cold turn ignition on,let the warming light go out then count to ten,i have to do this twice to get mine to start on cold mornings,when engine is hot then just wait for the diesel warming light on the dash board to go out and that will do it,takes roughly 3 seconds to go out.
You may have to repeat these steps 1 or 2 times. Turn key on ( do not start ) push gas pedal all the way to the floor and let off 3 times. Then turn key off and then start engine.
There is a problem with the emmission system are transmission and the computer turns the engine light on to let you know there's a problem. Have engine scanned with a OBDII engine scanner.
Turn key on. DO NOT START, PUSH GAS PEDAL all the way to the floor 3 times being sure to let all the way off each time. Then turn key off and then start engine.
Well, to start with, the check engine light is to let you know that you are having a problem with the car. It means to go to a technician and have it checked out. Also the RECALL LETTER is to let you know that the National Transportation Safety Board has determined that there is a condition (defect) that needs immediate attention. All of this is to keep you from breaking down and having to walk.
love,like,live,let,lettuce,light
As fast as its engine will let it. Or about 65mph. Different engines and tires will change this.
the sidestand switch is wired so that if sidestand down and engine in any gear but neutral it will not even turn over let alone start-a comon prob on many mcycles is when this switch malfunctions-along with the clutch switch which only allows engine starting when cluch is actuated