Chevy Silverado
Ford Crown Victoria

Windshield wipers wont turn off?

001

Top Answer
User Avatar
Wiki User
Answered
2014-06-13 22:02:04
2014-06-13 22:02:04

A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


There are a few different reasons why your windshield wipers may not turn off. You may for example having an electrical issue within the car.


chevy has bad solders. they crack and cause things to malfunction. mine does the same thing.


Windshield wipers not turning off is not a common problem in the 1997 Jeep Wrangler. Remove the windshield wiper fuse to turn them off.


I have a 2003 Acura TL. When turn on my windshield wipers, I'm not able to turn them off unless I turn off the car. The intermittent also doesn't work on the windshield wiper swith.


If the windshield wipers won't turn off on a 2000 Chevy Blazer, check the wiper relay switch. This is usually located in the engine compartment fuse box on top of the battery.


The windshield wiper switch is broken which is located on the windshield wiper motor. You need to replace the whole motor to fix this.


I have the same problem in my caprice, what you need to do is just sit there and switch it to high for a few minutes, then eventually if you keep playing with it it will turn off when you switch it to the far left


If the windshield wipers do not turn off in the vehicle, there could be a short between the battery and the wiper motor. It is also possible that the motor is malfunctioning due to the motor not being properly grounded.



Turn the wipers off, pull the wiper arm off, and replace it in the correct down position.


remove the wipers, turn on wiper switch, turn off switch, reinstall wipers @ bottom position torque nuts enough to secure the arm. turn on switch readjust as needed.


The windshield wipers were invented to wipe things off your car so you can see




the wiper switch is probably broken internally or shorted out.


Just by pressing " P " again P - Wiper On/Off


The linkage for the wipers could have slipped. If the linkage is not aligned right, then the wipers will not stop at the right spot.


Unfortunately you need to replace the wiper control inside. Look it over closely, if your not comfortable doing it then take it to someone you trust for repairs.


From the way that question sounds, there is nothing wrong. When you spray washer fluid on the windshield, the wipers are supposed to automatically come on for probably 3 or 4 swipes, then turn back off - it's a convienience thing when you need to clean your windshield. If your wipers are coming on automatically at random times, then you probably have a loose connection at the switch.


I got the same problem did you ever find the problem


It sounds like the switch has gone bad allowing the wipers to run constantly. Have the windshield wiper switch replaced.


The windshield wipers are not automatic... the lever that controls the wipers have three positions and you will have to pull the lever down to the off position. The position below off is for mist. If you pull the lever to that position and let it go, the lever will go back to the off position.


sounds like a wiper switch contact is sticking i have the same problem on a old dodge truck


Yes you can. I did it to my 91 s10 however you wont have control over your wiper speed since its only a two position switch on/off. I have a 3 position switch on/off/on one for slow and one for high however I have not tried this out yet.


Well, I would recommend taking the windshield wipers off, and then try re-attaching it to the windshield. However, there is also the option of checking to see if the attachment is attached properly in the first place.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.