answersLogoWhite

0

What else can I help you with?

Related Questions

What about out put sensor an input sensor were are the located?

The year, make, model, engine info and exactly which sensors you are looking for would help.


Why are there two coolant sensors on your 1998 ford escort se?

One sensor would be for your engine temperature gauge and the other sensor for the OBD II engine management system


What would cause a 2001 Pontiac Grand Am's engine temperature gauge to not work?

Coolant Temperature Sensor


Where is the oxygen sensor located on a 2003 Pontiac Vibe?

There are two o2 sensors one before the converter and one after. There is a TSB (technical service bulletin) on the vibe o2 sensor. Depending on your milage your car may be covered. The heated sensor (sensor 1) is on the exhaust behind the engine. Trouble codes would be P0171 and P2195 for the TSB/recall.


Where is the oxygen sensor located on a 2004 Pontiac Sunfire?

In a 2004 Pontiac Sunfire, there are two oxygen sensors. One would be located in the exhaust before the catalytic converter. The other is located in the exhaust after the catalytic converter.


Are there sensors that would cause a 1997 dodge stratus to not start?

Yes, just about any sensor on the engine could cause a no start.Yes, just about any sensor on the engine could cause a no start.


If the O2 sensors were bad how would the car drive?

Depending on which sensor is bad the engine may run like crap and the check engine light should be on.


Where are the oxygen sensors bank 1 sensor 1 in a 2002 mercury mountaineer?

Bank 1 is the passenger side of the engine in your Mercury Mountaineer Sensor 1 would be close to the engine before the exhaust enters the catalytic converter ( upstream sensor )


Why would the engine on a Pontiac Grand Prix not slow down?

TPS sensor or maf. I seafoamed my entire car seemed to do the trick


Will a 2001 cavalier 2.2 work in a Pontiac sun fire 2.2 1997 will the harness and sensors match?

The engine and mounts will be just fine. Everything should match up identically. Only issue that COULD arise would be the O2 sensor; but the chances are slim. I recently swapped a sunfire engine into my cavalier, and it worked fine.


Why would a 2001 pontiac grand am turn over but not start?

Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.


Why would crank sensor work after pouring water on it?

Sensor failure is often heat related , when crank sensors first start to go out they often have an intermittent failure when the engine is at full operating temperature. You are cooling the sensor with water.