0
What else can I help you with?
How much would it cost to replace a freeze plug on a 1993 cutlass?
It would depend on which freeze plug. Some are easy and some are not.
If you need a freeze plug can your car run hot?
I think you would know if you needed a freeze out plug for you would be losing coolant & losing coolant would make your ride run hot.
Why would 98 jeep wrangler blow a freeze plug in the summer?
Most likely reason is that it is rusted out. Improper coolant to water ratio can help freeze plugs rust from the inside, and wet weather will help it along on the outside.
What part in the cooling system can fail between the engine and transmission on a 1993 ford aerostar?
3.0 Liter V6: freeze plug
What is the size of 351 windsor block freeze plug above starter. I know that is a its a npt pipethread?
If it is a freeze plug it would not have threads. Freeze Plugs are designed to pop out of the block should the water in the block freeze. This could not happen if the plug was threaded. Hope This Helped.
1994 Honda Accord freeze out plug?
no such thing,freeze in plug
Why would anti-freeze leak from under the car?
Failed gasket, seal, hose, freeze plug, radiator.......
What is a better type of freeze plug?
The steel freeze plug is better than a brass freeze plug. This is because the steel freeze plug can withstand high temperature from the engine block. Moreover, the steel freeze plugs usually fit very well.
What is the best freeze plug rubber or the brass freeze plug?
Steel or brass freeze plugs are the best ones,rubber freeze plugs are just for temporary
Freeze plug 1997 Ford Escort?
how many freeze plug at 1997 ford escort
How do i change the freeze plug on driver's side on a 2.8 v6 engine on a 1988 ford bronco 2 xlt?
Locate the bad freeze plug and remove parts that impede the facilitation of reaching the plug. Take a screwdriver and hammer out the old plug. Replace the plug with either a regular plug (a socket that fits the inside of the freeze plug helps) or a rubber expanding freeze plug.
How do you replace a freeze plug in a 1995 Ford Aerostar?
take a large screw driver and a hammer tap the old freeze plug in the block,replace it with a rubber freeze plug.tighten the rubber freeze plug with a wrench..the metal freeze plug that you pushed inside the block will not hurt anything..hope this helps!!!!
