Want this question answered?
Unless the solute is frozen , the temperature and pressure in a room should not change the neutralization of a solute. This is because the solvent and all other aspects of the experiment would be equally affected, and the solute's temperature would balance itself out.
It could be many things such as temperature or pressure.
It should but it probably will not because of: experimental error measurement error calibration error (zero error)
They should try again. Then check very carefully and see if they did the experiment correctly. They may have to change their hypothesis.
Variable means 'can change'. If a science experiment is to produce clear information, we should change only one thing at a time. The condition we change is called the independent variable. For instance we might decide to change the temperature of hot water and see how that affects how long potatoes take to cook in it. Temperature is the independent variable, and cooking time is the dependent variable. If we want to be sure that changing the temperature is the only thing affecting the results, we must ensure nothing else changes from run to run. We must keep the size of the potatoes, their variety, the amount of salt in the water and the cooking vessel the same. These are the controls, or control variables.The controls are the substance or material or measurement in the experiment that stays constant and doesn't change while the variable is the object compared to the control which varies in results and can change through out the course of the experiment.
temperature
Unless the solute is frozen , the temperature and pressure in a room should not change the neutralization of a solute. This is because the solvent and all other aspects of the experiment would be equally affected, and the solute's temperature would balance itself out.
if you could only record a single temperature reading in a freezing point determination experiment, which temperature should you record
temperature
2
8
The grammer is wrong here...should be "what change is observed when a leaf was boiled in warm water in an experiment".
The conclusion for a lava lamp experiment depends on the thesis. If the thesis talks about the temperature for example the conclusion should reflect that.
It depends what kind of experiment you do. For some you just need one. For others you may change two variables. In most cases you only change one
It could be many things such as temperature or pressure.
temperature
Static variables (should) remain the same e.g. temperature of a water bath, k constant of a particular spring. Dynamic variables change as the experiment progresses e.g. air temperature and pressure, amount of natural light.