It could, along with many other parts.
2.5l = 1-3-4-2
You would have to change the fuel and ignition systems over to a non computer system.
The engine is governed by the computer module. You will have to purchase an after market module w/o a limiter.
the problum is your on board computer. it controls the firing of you spsrkplugs. have seen this problum quite often.
Many reasons, but a common one is a faulty neutral safety switch, try starting it in neutral.
No, it will not.
The difference between the 5.0 and 5.0 HO is primarily in the firing order. The HO shares the same firing order as the 351W. You would need the cam for sure. If you are running a carb and pre computer ignition you'd just need to change the routing of the plug wires. Fuel injection would require the correct programming in the computer. I suppose it would be possible to fool the computer by re-routing the injector wiring to the appropriate injector for the HO firing order.
No. The entire driveline would need to be replaced. You could if you change the engine, trans, wiring , computer, radiator,.......
My jeep wrangler keeps loking in gears
the firing order is 1,5,4,2,6,3,7,8 the cylindes are starting at the front on the pas. side front to rear 1,2,3,4 and on the drivers side front to rear 5,6,7,8.... hope this helps
yes it would or it might be the starter
on a 95 it would be starting from the front left would be one then the right front 2 then the 2nd left 3 then right 45 63 41 2