answersLogoWhite

0

Seized engine?

Weak battery?

Corroded or loose battery cables?

Bad starter or starter solenoid?

Bad neutral or clutch safety switch?

Bad ignition switch?

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why does 1995 Ford Escort LX not start when ignition switch clicks with key but engine doesn't turn over and instrument panel lights on without key in ignition and radio heater and lights work?

you need a new ignition tumbler.


Is it normal for the check engine light to come on with the key turned on but not stay on until engine is started?

It is normal if other lights come on at the same time. All of the reminder/warning lights should come on when ignition is in idle (key's in ignition, but the car is not running)


What can make a battery drain when car is not running?

mainly leaving your lights on when the engine is of or leaving the keys in the ignition


How do you reset engine light in 2002 rsx?

switch ignition to on and press and hold the odometer reset button until the engine lights goes off.


Car will turnover but not start how do you fix?

Answer checkn see if u have spark,getting gasfirst test the battery if it is low then charge it check witch lights come up when u turn the ignition on and check rad water and engine oil It's not a good Idea to check for sparks on a car with computerized engines.


If a 1998 Pontiac Transport 3400 starts but stalls out what should you check?

There's a solinoid in the transmission.Suggest to check that first. Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.


How do you reset the warning lights on a 2005 Jeep Grand Cherokee?

To reset the warning lights on a 2005 Jeep Grand Cherokee, start by turning the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within ten seconds. After that, turn the ignition off and then restart the engine; the warning lights should be reset. If the lights remain on, it may indicate an underlying issue that needs to be addressed.


How do you reset the air bag and sit belt lights on Infinity J30?

To reset the airbag and seat belt lights on an Infiniti J30, first, ensure that the ignition is turned off. Then, locate the airbag diagnostic connector under the driver's side dashboard and use a jumper wire to connect the two terminals. Turn the ignition key to the "On" position without starting the engine, and the lights should reset after a few seconds. Remove the jumper wire, turn the ignition off, and then start the engine to check if the lights have turned off.


Why do the engine warning lights come on when the car is off?

By "OFF," I have to assume that your question means that the ignition switch is "ON", but the engine is not running. IF that is what your question means, then the reason the engine warning lights turning on is that the manufacturer designed the system that way to show you that those warning circuits and lights are working, and ready to warn you after you start the engine, should there be a failure in one of the systems they represent.


How do you reset engine management lights on astra?

Press and hold the mileage reset button turn the ignition on wait for 4 dashes to appear, switch ignition off job done ! this will not work. this only resets your service light and not the engine managent light.


Why is Engine still running dashboard lights dim but on key in hand?

What kind of auto is it. Sounds like you may have an ignition switch problem.


When i turn my engine off the fan comes on after jiggling the key the fan turn off but the lights on the dash stay on why?

You may have a bad ignition pig tail. It is in the steering column behind the ignition switch.