0
What else can I help you with?
How can I determine the amount of electricity consumed by a device or appliance?
To determine the amount of electricity consumed by a device or appliance, you can use a device called a wattmeter or check the device's power rating in watts and the time it is used to calculate the energy consumption in kilowatt-hours.
What is a user trying to determine when issuing a ping 10.1.1.1 command on a PC?
If there's connectivity with the destination device
What would you need to know to determine the total amount of photosynthesis?
By using a ppm device
What is the correct usage of the IPCONFIG command to help troubleshoot a home network?
Use the IPCONFIG command to determine the IP address, Subnet Mask and the Default gateway address of the local device.
What Device used to select amount of voltage in primary coil of step up transformer?
There is no selective device to determine the amount of voltage. A transformer is selected by the voltage available at the site for the primary and the load on the secondary side of the transformer.
What command do you use to determine whether you can reach another computer on the local network?
"ping" will test for connectivity to a device at the Ethernet Address Level...but that does not mean the device's software is actually talking to the network or responding to the network. "ping" WILL tell you the device is wired up and has power applied to it's network interface board.
What are three factors that determine the amount of electrical energy?
The power rating of the electrical device or system. The duration for which the device or system is in use. The efficiency of the device or system in converting electrical energy into useful work.
What does the command no shutdown do on a Cisco device?
Enables the interface.
What is the longest Show command in a Cisco device?
The show tech-support command will give you the longest output.
What is the mount command in Linux?
The mount command instructs the kernel to access the file system on a partition or device.
What command will allow you to see the connections made from your router to remote device?
The command would be show connections.
What command in LINUX do you use to mount a USB storage device (ex.USB device listed is sdal?
mount .
