0
You got a code 26 Quad Driver Module do you change your whole computer what should you do I have a 1993 Ccamaro Z28?
818pacas
I would take it to a repair shop and have them check it out. If indeed the quad driver is defective you will have to replace the computor.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can you change the Quad driver module on a 95 Saturn SL2?
The quad module is in the computer.....Most likely the problem is one of the sensors it controls....Most common is cooling fan relay or motor OR EGR solenoid, or Evap purge solenooid
How do you change the idle on a 2004 Ford Explorer?
The idle is controlled by the powertrain control module ( computer )
Can you change the code for key lock entry on driver door?
You can change the personal entry code , but to change the factory code you have to change the RAP module and get new remotes ( as far as I know )
Can you change the intregrated power module fuse box or is that a dealer install?
If the computer is invovled, it is a dealer install only.
How to change 2000 Montero Sport air bag module?
The airbag module in most Mitsubishi vehicles is located behind the steering wheel for the driver and behind the dashboard for the passenger. They can be replaced by disassembling the ECU brackets.
I replaced the ignition module and coil packs and need to know what sends the signal to the module?
sounds like we are having the same type of issue, I replaced ignition Module and coil pack, and still no spark the last thing to change is the Computer.
Where is the turn signal flasher module on a 2003 Town and Country van?
Don't know if they have one. Now use "body computer" for that function. If there is one, its above the driver's feet up under the dash. My 2005 doesn't have one I found out, not sure when they made the change.
How do you change the factory set keyless entry code on the computer module of your 2002 Eddie Bauer Ford Expedition?
You can not change the master code yourseft. Only the dealer can.
How do you change the driver's name in the memory of a 1997 Buick Park Ave?
the dealer attaches a little computer to it and does it for you...
How do you delete the electronic control module on a jeep wrangler ' 88?
You would have to change the fuel and ignition systems over to a non computer system.
Where is the computer module on a 2000 Mercury Sable?
I assume that you are reffering to the Powertrain Control Module (12A650). This is located on the firewall down from the passenger side windshield wiper. You can see the 104 pin connector comming out of it. I think I need the location of the chassis computer. I bought the car used and it has the keyless entry number pad on the drivers door. The manual says that if I know the factory code I can use it to open the doors, or I can change the code. I have no idea what code is in the computer, but the manual says the factory code is taped to the "computer module". Any Help on where this module is located?
If you change ths computer will it change the code on the door for a 2000 Mercury Mountaineer?
If you change the RAP module ( which is located in the storage compartment where your tire jack is ) that will have a different factory code ( I believe you have to get new remotes also )
