Want this question answered?
Trouble code P0200 means: Injector Circuit Check all injector circuits
Trouble code P0203 means: Injector Circuit / Open - Cylinder 3 I think you need to replace the Injector on cylinder 3 ********************** Remove the air intake snorkle that covers the #3 and #4 injectors. On the bottom of the snorkle you should find a metalic pad. Now, look at the wires that feed the #3 injector. If the injector is turned to just the right position, the wires can rub on the metalic pad. If it wears enough it will rub through the wire insulation and you will be able to see copper stranded wire as a result. To repair this, place some automotive-type silicone gasket maker (in a tube), covering the bare wire and then allow to dry for 24 hours. Also, turn the injector 45 degrees (either right or left) to move the wires away from the metalic pad. This will effectively lower the wires so that they won't rub. Another thing that could be done is to add a 1/4" spacer under the snorkle bracket on the front locating stud. This will also increase the space between the bottom of the snorkle and the #3 injector wiring harness/connector. If this doesn't fix the problem then it's probably your injector.
Misfire on cylinder #3, not sure of the cause (no spark, blown gasket, injector problem).
Replace the bad injector.
Replace the O-ring on the injector.
where is the #5 injector? how long does it take to fix
no fix,replace with new only.
Found what? If the injector is leaking, no O Ring will fix that. Replace the injector.
driver side deployment circuit open
A fuel injector on the vehicle is not serviceable, replace it with a new one.
Struts is an open source framework that is created/marketed by the Jakarta commons project. It is an open source and so you can also get the source code of the struts framework. If you feel the code has any issues, then you can fix them in your code, test them and contact the Jakarta commons project and have the fix implemented.
one of my injector are leaking and can I fix that by replacing small o-ring? Thank you