Had similar problem on 1987 lebaron replaced starter relay under hood driver side over wheel well next to cooling fan relay.
It was replaced by the Chrysler Sebring.It was replaced by the Chrysler Sebring.
It is true to say that Halo headlights bulbs can be replaced.
Check the fuse for the headlights. It is probably open.
Yes they sell restoration kits for headlights
The headlights run on a different fuse from all other lights. Locate and check this fuse. Also the headlight switch may have a circuit breaker inside and after time it will get weak and not reset. Check for power to the switch and if you have power to the switch and then the switch has gone bad and should be replaced.
A fuse needs replaced.
have you replaced the dimmer switch? if not that may be the problem. I had the same problem in reverse( brights worked but headlights didn't) water damaged the dimmer switch on the steering column once I replaced it all was good.
I filanny got an answer. Echo taillight bulb is also break bulb. This bulb has TWO filaments in it, one for taillight and the other for breaklight. My case was taillight filament is gone, but breaklight filament is OK. Answer is "change the bulb" Model number is 7443, (not 7440, which has only one filament for breaklight). Google 7443 bulb or check below site, it's only 6 bucks. http://www.partsamerica.com/ProductDetail.aspx?MfrCode=SYL&MfrPartNumber=7443 Hope it will be helped to you~!
The solenoid pack on a Chrysler Sebring is on the bottom of the transmission. It is a bolt on unit and can be easily replaced.
It was a factory option. It should be replaced when dirty.
I replaced the voltage regulator, and that did the trick.
If by "dim headlights" you mean low-beams... the bulbs are bad and must be replaced.