answersLogoWhite

0


Best Answer

flush the radiator

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: You have replaced the thermostat in a 1994 Mazda B3000 and the engine temp gauge still runs to the hot side Do you need to bleed air out of the coolant line?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil filter on a MAZDA B3000 truck?

On a 2002 - it is on the drivers side of the engine toward the back. It is replaced from the top of the engine. If the engine is hot, do not try and change or be very careful


Pcv valve location on a 1999 Mazda b3000?

On a 1999 Mazda B3000, the PCV valve is in one of two places, depending on the engine. On SOHC 4-cylinder engines, the PCV valve is mounted on the oil separator on the left side of the engine. On DOHC 4-cylinder engines, the valve is behind the coolant bypass hose..


What would cause a 2002 Mazda B3000 to overheat for 10 seconds and then return to normal?

Bad thermostat


Who makes engine in Mazda b3000?

Ford Motor Company


Does the Mazda B3000 truck have a non interference engine?

A Mazda B3000 truck does not have a non interference engine. These engines are designed to survive catastrophic timing failures due to lower tolerances.


How do you stop a water leak on inside firewall passenger side of B3000 Mazda truck?

The leak is probably caused by a faulty heater core. The heater core will have to be replaced. In an emergency, the hoses can be pulled off at the firewall from inside the engine compartment and spliced.


Where is the camshaft position sensor on a 2003 Mazda B3000 3.0L pickup?

i just had mine replaced by a mechanic and he told me it was sitting on top of camshaft


Why does my1994 Mazda B3000 overheat?

These are the possible causes of overheating listed in Haynes Repair Manual #36071; 1994 - 2005 Mazda B-Series Pickups: (1)insufficient coolant in system; (2)waterpump drivebelt defective or not adjusted properly; (3)radiator core blocked or radiator grille dirty and restricyed; (4)thermostat faulty; (5)fan blades broken or cracjed; (6)radiator cap not maintaining proper pressure - have the cap pressure tested by gas station or repair shop. Engine overheating can be caused by one of several problems: Sticking thermostat, if that's the case, replace the thermostat. Low coolant level, add coolant to solve that problem. Blocked or plugged radiator, radiators can build sediment and sludge and eventually get to the point that coolant doesn't flow through, causing the engine to overheat. Corroded or worn water pump blades, replacing the water pump cures that problem. Cracked block, head or blown head gasket, typically caused by prior overheating (see the above reasons) which caused the damage to the engine. If the head or block is cracked there isn't much you can do except to replace the failed part. If the head gasket has blown it's typically because the head warped while the engine was hot and a warped head does not provide enough even pressure against the gasket to keep it from blowing out the side. Just a very small amount of head warping will cause the gasket to blow out. A warped head can be machined and it will be as good as new. A blown head gasket allows exhaust gas under extreme pressure to release into the cooling jacket of the engine. When that happens, there is quite a bit of pressure that blows the coolant out of the engine and the engine will overheat because of insufficient coolant. I hope that's not your problem. Thermostats and water pumps are easier to replace.


What is the difference in the Mazda trucksb2200.b2300.b3000 ect?

The difference is the size of the engine. B2200 is 2.2L, B2300 is 2.3L, etc.


When to change a timing chain B3000?

You change the timing chain when you overhaul the engine. They will last the life of the engine under normal circumstances and are not an item you replace as a part of regular maintenance.


Where is the engine control module located for a 1994 Mazda B3000 Pickup?

If you mean the Power Control Module, it is located on the passenger side of the engine compartment, along the upper edge of the firewall.


How to remove and replace Mazda b3000 fuel injectors?

how do u replace fuel injector on 2001 b3000