check the hull for cracks/holes. check the foam on the inside of the hull if possible. if it is decomposed you could stuff all the strofoam you can into the hull incase it takes on water the foam should keep it afloat (assuming you have enough). seal everything that will be under the water with fiberglass resin and you should be good to go.
How often should you change water pump in a boat
What should you do to prevent a traffic jam on the boat ramp
What is it
It means that someone is in the water and other boat drivers should be cautious of the person in the water.
jump in the water
Yes, but the effect should be minimum. As water cools it becomes more dense, Meaning that there is more mass per volume. As a boat moves through a given volume it must displace some of the water. Since ( F = M * a ) the boat must exert a certain force to move an amount of water. If there is more mass in that certain volume the boat must exert more force, thereby slowing the boat.
Destroy everything around it and if something falls out, build it onto the back of the boat. It should make one of them push things. Just go behind it and push it, then the boat should go into the water.
Turn off the engine.
This question depends on the type of boat you have. Normally as long as your boat can do around 25+ mph you should be able to pull a skier out of the water. So if you have a 18ft boat with a 115hp depending on the weight of the boat you will be able to tow a skier out of the water.
if you are taking the boating test the answer is a
if you are taking the boating test the answer is a
The key to make a boat float is that the boat should weigh less (or have less mass) than the water it displaces.