have you checked the axles are in the correct position, make sure they are all the way in sometimes the axles were not installed correctly. make sure they are in the correct position
next to the left muffler throwout bearing tdc sensor
the slave cylinder is either located just above the starter or its an internel one part of the throwout bearing.
Yes, the clutch throwout bearing is hydraulically operated.
check your fluid level for the clutch master cylinder or the throwout bearing, the clutch release bearing could do this too.
Yes
no. the clutch master cylinder is under the hood, typically near the brake master cylinder, and the slave cylinder is underneath, connected to the fork and throwout bearing on the transmission.
A throw out bearing is the bearing in a manual transmission that helps to engage and to disengage the clutch.
You're gonna hafta drop the entire tranny to get to the clutch, pressure plate, and even tho throwout bearing/ slave cylinder.
have to take the transmission out and its behind the clutch slide it out and make sure you put the throwout bearing in the same way the old one comes out
Both are the same term for the same part.
Yes
you have to remove transmission to take out and replace throwout bearing