It sounds like a suspension problem. It could be the ball joint or the control arm on that side. Also, maybe a tie rod. I'd get it checked before it snaps.
AnswerBetter have the front knucles checked on the front axles. Sounds like you have one out. Get it fixed before you cause any further damage. AnswerI had a similar problem. Torsion bar mounts. chev GLUES them in and they losen in time. That's your best bet. Answermy blazer has the same problem its either the idler arm, pitman arm, center link or one or more of the above.its a Chevy
Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.
It could be the ball bearings or the ball joints or the breaks but not to sure but that's what it was on mine.
that is either your front right wheel bearing or your coil spring is turning need new suspension..$$$$
Yes.
can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer
my Chevy blazer power seat on my 1996 Chevy blazer isn't working
Fit 96 grill in 95 blazer
HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER
Yes
Where is the horn located on a 1993 chevy blazer
An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.