answersLogoWhite

0


Best Answer

On mine, when the lights are off, the left brake light is faint but still works. When the lights are one, the running light is on (faint) but goes out when I hit the brakes. And the turn signal doesnt ever work. When Ive checked the light bulbs they burn out fast. I have been told that replacing the plastic bulb housing will fix this. But I have not tried it yet.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 88 Chevy pu has brake light on the right and turn light but nothing on the left?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is sylvania longlife 3157 the right bulb for a brake light on Chevy trailblazer 2004?

Yes.


Chevy Malibu right side brake light not working?

A couple things can cause your right side brake light to stop working. The most common cause is a burnt out lightbulb. A loose ground wire can also cause it to stop working.


Where does the brake light switch go in a 2005 Chevy Cobalt?

usually the brake light swith is up under the dash right above the brake pedal itself. I have an 09 cobalt and it has a u shaped tab that rides on the side of the brake pedal arm on a small stud that sticks out.


After replacing the fuses bulbs and brake light switch the tail and brake lights work and then fuse blows 97 Chevy PU?

If memory serves me right, each tail light assembly has a printed circuit board that the bulbs plug into. That circuit board burns out. That part is available from the Chevy dealer.


How do you fix 1996 Chevy lumina brake lights Only my right brake light went out?

1996 Chevy Lumina brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the brake light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).


How do you change the brake light switch on a 1995 Chevy G20?

your in luck i just had to do this on my 95 lol you will have to carefully lower your steering column, and above it there is the brake light switch conected to the brake pedal and a rod going towards the front of the vehicle where the master cylindar is at. on the little piece sticking out to the right of the brake light switch there is a pin that keeps it in place. remove that pin and then remove the wires connected to the switch. should come right off and then just put the new brake light switch on and reverse the steps. hope this helps


How do you change the brake light switch on a 1992 Chevy Lumina with Cruise control?

the brake light switch is located on the brake padal bracket just to the right of the steering column mount. you'll need to remove the left underdash sound panel beneath the steering column to get to the switch and connector.


How do you disconnect the parking brake cable on my 2003 Chevy Astro van?

If im thinking right about your problem you are showing a light on your dashboard....can be cause bcs cable its stuck or a rear brake cylinder or drum its bad....


What side is the emergency brake on a 1991 Chevy Camaro rs on?

the emergency brake is on the right side on the console


What fuse is the brake lights on 2000 ford expedition?

The left brake light works the right brake light doesn't and the bulbs is good


How do you change brake light switch in a 1996 Chevy silverado?

on the brake pedal under the dash there will be a king pin pull it out and remove the stud and the switch should come right out then dosconnect the wireing harness and replace switch


Where is the brake light switch on a 1996 Avenger?

It is underneath the Brake Pedal.It's mounted to and right above the brake pedal.