answersLogoWhite

0


Best Answer

lack of gas. (bad fuel pump and or clogged fuel filter) Bad spark plugs or plug wires. and mid as well get a new air filter.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 95 gmc G2500 vandura van will start and run in idle put as soon as you put it in gear it will die?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When to use first gear?

well. whenever you have a low idle, you use first gear to accelerate. if u have a higher idle or throttlebody, you can just start in second gear.


What is a idle gear?

good gear


What is idle gear?

good gear


Mercury outboard motor start and idles but stalls when you put in gear.?

outboard motor will start and idle, but dies out under load


I have a 95 Mitsubishi Galant that will idle fine but dies when you put it into gear I have already replaced the idle air control motor could it be the computer Or the transmission?

No, you may have to check your idle. You can change the idle so when you put it into gear it will not die. You must make sure that the engine is warm when you adjust the idle or it may make it hard to start when the engine is cold. When it idles in park or neutral it should sound a little higher than when it it idles in gear or drive or reverse.


If my 2001 Cadillac DHS sometimes won't start and idle or just dies sometimes what is causing this?

If a 2001 Cadillac DHS sometimes won\'t start, becomes idle or just dies it\'s probably a problem with the gear box.


Why does your motorcycle idle fine but bog out when in gear?

Your motorcycle might idle fine and bog out when in gear because of a problem with the carburetor or the bowl. If either area is dirty, it will often bog the bike when in gear.


Where do you set the idle on a 1991 dodge cummins pick up?

You will want an idle speed between 750 and 900 rpm with the ac on and in gear (if auto).You will want an idle speed between 750 and 900 rpm with the ac on and in gear (if auto).


What is the cause polo classic idle goes down when you shift gear?

Is that when you shift INTO gear? It's supposed to drop a little - 150 to 200 rpm - when you put the car in gear. If it drops 500-600 rpm, start by looking for vacuum leaks.


1986 mustang with new battery dies when put in gear and doesnt start without jump any ideas?

Check the alt & idle speed.


Why would your automatic car start fine idle fine but when you put it into gear it stalls?

IF IT IS A MANUAL TRANSMISSION CAR, THEN IT SOUNDS AS IF YOUR CLUTCH IS BAD/WORN OUT.


Why would your car shake when it is in gear and and idleng but not moving Same for when not in gear shakes when it waunts to out of gear. but shake when in gear and at idle?

Check your motor mounts.