well. whenever you have a low idle, you use first gear to accelerate. if u have a higher idle or throttlebody, you can just start in second gear.
First gear and drive slowly
To use a gear puller effectively, first, position the puller over the gear you want to remove. Then, tighten the puller's jaws securely around the gear. Finally, use a wrench to turn the puller's center screw, applying pressure to pull the gear off its shaft.
My car has lots of torque in first gear.
It tells you your second gear start switch is on. When on, that switch makes the transmission not use first gear. This is good for icy winter conditions.
Incorrect gear ratio in first gear.Incorrect gear ratio in first gear.
You need the right gear to ride a motor bike. First gear is needed to move the car from a standing start Lets spend a day our with the fishing gear We need the right gear to bring about a satisfactory result
To use a gear puller effectively, first, select the appropriate size and type of gear puller for the job. Position the gear puller over the gear to be removed and ensure it is securely attached. Apply pressure evenly on the gear puller handle to slowly and steadily pull the gear off its shaft. Be patient and avoid using excessive force to prevent damage to the gear or surrounding components.
To find the torque of a gear, you can use the formula: Torque Force x Distance. First, determine the force applied to the gear. Then, measure the distance from the point where the force is applied to the center of the gear. Multiply the force by the distance to calculate the torque.
bog down in first gear and then it strtes to shift
Enhancement shaman should be using mail agility gear. There is BoA gear that is mail agility. If you want to use the BoA gear, this is the only gear that will give the enhancement shaman any use whatsoever. The mail intellect gear has no use for an enhancement shaman.
To remove the gear shift knob on the SLK 320, first pry the cover from the gear shift knob. Then, use a screwdriver to remove the screw in the center of the knob. This will then allow the knob to be removed.
Yes, you can use 75w-90 gear oil instead of SAE 90 gear oil