answersLogoWhite

0

Your B18a1 Motor Strarts But dies After 10sec?

Updated: 8/17/2019
User Avatar

Wiki User

15y ago

Best Answer

Check your fuel...

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your B18a1 Motor Strarts But dies After 10sec?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does a motor boat slow to a stop when the motor dies?

Resistance. Water has a lot of resistance.


Mercury outboard motor start and idles but stalls when you put in gear.?

outboard motor will start and idle, but dies out under load


Whats wrong 1991 dodge dynasty starts then dies?

what is a controller in 2.5 motor in a dodge


1995 GMC Van Any idea why motor intermittently dies when heater turned on?

there is a vacumm leak .


1993 cadillac dies while driving Won't restart hot?

There is a sensor that kills the motor if it gets too hot. This is so the motor win not be damaged by high heat.


Motor dies when put into gear?

A motor will die when put in gear if there is a major vacuum leak. This causes an excessive amount of air to enter the engine and lean out the fuel mixture.


Why does your car die during travel?

maybe your car gets over heated or your motor dies i have had the experience trust me


If a spouse dies in a motor accident can you claim of your car insurance?

Yes. But get some help for this. A lawyer or knowledgable friend.


On a 2000 Ford Explorer what is the problem when it is running and you put it in reverse or drive the motor bogs down and dies?

sell it


I have a 2003 Chevy impala how do i know if i have a bad battery or bad alternator?

To test the alternator if funds are low, let the motor idle and remove the negative battery cable, if the motor dies its probably the alternator.


Dodge Stealth 3.0 when you brake it dies out and then it restart fine just when you stop?

check and or clean air idle speed motor


Replaced IAC and throttle positoning motor still dies?

Have you checked the computer codes? If the computer is not giving you a fault code you probably don't have an electronic problem. When an engine dies and there is no fault code it's usually related to fuel pressure.