answersLogoWhite

0

clean jets and check fuel filter

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Yamaha blaster sev troubleshooting problems?

My Yamaha Blaster stalls when I engage the throttle, what should I do?


What is the top speed of a bored out 220cc Yamaha Blaster?

Boring the engine out will not help the top end speed. This Blaster will go at top end 55 mph at the full throttle.


When you push on the throttle on a 1989 Honda Prelude it goes then when you stop at a light it stalls?

May be a vacuum leak


Stalls when the heater is turned on?

take negative off battery for 30 minutes and clean the Throttle Body


What cause 1994 Dodge Dakota stalls when you barely give it gas?

Try the throttle position sensor


Why does My 1996 fiesta seem to kangaroo at certain throttle positions and then when more throttle applied it seems ok and also it sometimes stalls on stopping?

Must be a wallabee in the carbureator.


What is wrong when your 2000 acura tl stalls upon starting the car?

Most likely a Throttle position sensor


Whats the problem On a 1988 civic the check engine light turned on and the car stalls when the gas is pushed?

it might be your throttle


Chevy s10 1993 that stalls on idle What could be the reason?

throttle positioning sensor, egr, idle air control


Your 04 Chevy trail blazer almost stalls when you turn on ac?

This is a dirty throttle body. Very common on our trucks.


Car stalls when put in gear?

if its a manual then it could be three things, clutch cable or throttle cable, or IAC (idle air control valve) but if its an automatic it could be throttle cable or IAC.


Your Yamaha blaster revs up real high after you push the choke back in and then stalls out?

Have you changed the main jet? Sounds like needle not seating fully or correctly.