Fill the 5 liter container.Pour it into the 8 liter container.Fill the 5 liter container again.Pour it into the 8 liter container again, but stop when the 8 liter container is full.The 5 liter container now contains 2 liters.
First you put some oil into a pan and break an egg and put inside parts on to a pan. Then you wait for the egg to fry and you flip the egg over for about 2 times and it is DONE!
A sauce pan is a sauce pan, its not a measurement
Le Creuset Technique Series With Michael Ruhlman - 2012 Pan Fry 2-1 was released on: USA: 1 August 2013
hi there you can pan fry green beans , place your beans in a pan on a low heat and drizzle lightly with oil .Cook them on the low heat for 2-3 minutes to prevent burning or overcooking the beans.There are also recipes out there for cooking them like asparagus.
No
Put oil in a fry pan break how many eggs you want to make in to a bowl . Then put a good measure of salt and then stir wait about 2 minutest then put the eggs onto the fry pan and then wait till it fries and you're done!The above suggestion will produce a meal, but it will not be a fried egg; rather it will be a scrambled egg or omelette.To fry an agg, put a little oil into a pan on a moderate heat. When the oil is hot, break the egg into the pan, turn the heat a bit lower and (preferably) cover the pan with a lid to keep the heat in. The egg will cook very quickly - so do not allow the yolk to go hard, nor let the edges sizzle.
I don't care I mean, what kind of stupid question is that?
You can buy a breeding trap for the fry once they are born feed them liquid fry food
Well if the mole can fit into a two liter bottle, then obviously it would be two liters.
BIG!!! it will look like its about to explode
You have to jack the car up and rest it on jackstands. Drain the oil by reoving the drain plug (the big bolt on the oil pan). Remove the crossmember underneath the oil pan by removing the bolts on both ends. Then remove the bolts holding the oil pan onto the block and remove the pan. Take note of the 2 bolts that are longer than the rest, these go where the support brackets for the transmission cooler lines are. This is I removed the pan on a 97 Nissan Pickup with the 2.4 liter engine.