To tighten the chain on this model four wheeler, one must first loosen four bolts located on the swing arm axle. Then rotate the chain counterclockwise, and tighten those bolts back down.
you tighten it derrr!!
I had the same problem, but then I looked at the rear tires, the one on the right ( same side the chain is in ) was closer to the front of the four wheeler than the other tire. Then I lifted the rear of the quad and it was because my rear bearings were gone and needed to be replaced, which would pull the rear tires back in line tightening the chain.
I had the same problem, but then I looked at the rear tires, the one on the right ( same side the chain is in ) was closer to the front of the four wheeler than the other tire. Then I lifted the rear of the quad and it was because my rear bearings were gone and needed to be replaced, which would pull the rear tires back in line tightening the chain.
It has an automatic chain tensioner..
under the cluch
anywhere from $150 to $2000..
To tighten the chain on a Polaris 300 Xpress, first, ensure the ATV is on a level surface and securely supported. Locate the rear axle adjusters, which are typically found on both sides of the swingarm. Loosen the axle nut and turn the adjusters clockwise to tighten the chain, ensuring it has about 1-1.5 inches of slack. Finally, re-tighten the axle nut and double-check the chain tension before riding.
Listed on the master cylinder cap.
The weight limit for a 125cc four-wheeler can vary depending on the specific make and model of the vehicle. Generally, a 125cc four-wheeler is designed to carry a maximum weight capacity of around 200-300 pounds, including the rider and any cargo. It is important to consult the owner's manual or contact the manufacturer to determine the exact weight limit for a specific 125cc four-wheeler model. Exceeding the weight limit can compromise the safety and performance of the vehicle.
need free picture diagram for 1997 honda four wheeler rear end
There are many factors that will affect the cost of four wheeler tires. The tire manufacturer, dimension of the tires and whether the vehicle is intended for on or off road use. Generally you can expect to pay anywhere from $140 to $300 for a complete set of tires.
If the measurement from the center of one lug to the next center is the same as your four wheeler than yes.