the cable needed is a 3.5mm male jack at both ends.
Changing a VW Polo clutch cable requires exposing both ends of the cable. An open ended wrench will be needed to loosed the existing cable. After replacing the cable, be sure to bleed the line to prevent failure.
The negative battery cable will short out if it is loose or corroded. Check both ends of the battery cable for corrosion. Make sure both ends are tight.
Clean both ends of both cables and if that doesn't do it, check the cable ends.
Coaxial Cable With RJ 45 Connectors at both the ends.
It is tedious job. Each cable must be disconnected from power, disconnected from the terminals. A cable needs to be thus disconnected from both the ends, marked at both the ends, release the cable from the cable tray or from the conduit so that the cable is not damaged.
50-ohm
sandbags
Match up the two ends of the cable. Look closely at the color coding of the pins at both RJ-45 connectors. If the same colors are used in the same pin positions then the cable is a straight-through cable. If they are reversed at both ends then it is a cross-over cable.Sometimes the cable will be marked that way on the outside covering of the cable. Look for the words "cross-over cable".
if it has a separate cable both ends of the cable are male and in the back of the computer and the back of the monitor is female
A straight or standard cable is wired the same on both ends. What color goes where is not important, as long as it is the same.
straight through is same pin out both ends. crossover has transmit and receive lines reversed
straight through is same pin out both ends. crossover has transmit and receive lines reversed