0
What else can I help you with?
In the owners manual for the 98 VW Jetta it says the fuse panel for the ciggarette lighter is located above the relays and is separate where is this located?
Relays are usually under your hood. They are going to be larger plug looking things inside a black box.
Can you use a cigarette lighter to plug in a cell phone?
you can use the lighter output,but not the lighter itsself.
How do i install neon rings on my subs i there is a lighter plug in with the on off switch and on the end is a plug were do i plug that plug into?
One end plugs into cig lighter the other end plugs into the neon light.
Your cigar lighter isn't working and it isn't the fuse please help?
there is a small plug on the back of the lighter, you have to take the lighter out, it could have vibrated loose
Where do you plug the OBD scanner on a 1999 VW cabrio?
there's a cap up the lighter with a engine, take it of and the plug is there
1997 Neon How many amps is the cigarette lighter plug rated for?
Check the fuse that the cigarrete lighter is hooked up to.
Can you plug your amp to a 12v cigarette plug?
No, the cigarette lighter fuse is not large enough to handle below nor is the wiring.
Can a 12v plug be used in the 1999 Subaru Cigarette Lighter socket Manual says only to use a Subaru made plug?
Use your 12V plug.
How do you stop a charging rhino?
On the lighter side: Switch off the plug socket.
How can you charge portable GPS in your 1997 Acura TL?
Plug it into the cigarette lighter.
How many amps does the actual cigarette lighter PLUG in the car draw?
25
How do you wire a 12 volt cigarette lighter plug on to a device like a backup camera LCD monitor?
To wire a 12-volt cigarette lighter plug to a backup camera LCD monitor, first ensure the monitor is powered off. Strip the ends of the wires from the monitor and the cigarette lighter plug. Connect the positive wire (usually red) from the monitor to the positive terminal of the cigarette lighter plug, and the negative wire (usually black) to the negative terminal. Secure the connections with heat shrink tubing or electrical tape, ensuring no wires are exposed, and then plug it into a 12-volt socket to test the setup.
