Epoxy is a copolymer They are often used during boat repair and assembly.
Epoxy resins are used with aggregate (silica sand) to produce epoxy mortar or epoxy concrete, which is used for structural repairs of concrete.
Epoxy resin can be used as a jointing compound.
The best sealers for copper pipe are a combination of plumbers tape and plumbers epoxy. The tape is used to temporarily seal any holes while the epoxy dries.
There should be no reason you cannot steam mop epoxy grout.
Yes, It can be achieved by using a knifing tool.
I like primer epoxy because it dries hard. But that's just me. It really depends on what your doing with it.
There are two methods to waterproof your floor. One is to apply a waterproof membrane prior to putting tile or carpet. Dal Tile offers a great product made by Laticrete. The second is to apply a waterproof flooring material. The current trend is urethane / epoxy quartz broadcast flooring systems. A substrate of urethane or epoxy based material is put on the floor. Then a sand mixture is broadcast over the urethane /epoxy and rolled with a paint roller to embed the sand into the urethane / epoxy. After that has dried, a urethane clear top coat is applied. The resulting texture on the floor will depend on the amount of sand used and how many topcoats of urethane. I wouldn't advise this for a do it yourselfer. It's messy messy. You should be able to get it professionally done for less than $10 a square foot.
A good epoxy such as 'Speedfix'.
Yes, it is always necessary when carrying out repairs . The area surrounding the repair is sanded , and the primer patch extends outside the repair onto this "feathered" area. Both epoxy and urethane based primers are suitable.
Epoxy resins are used with aggregate (silica sand) to produce epoxy mortar or epoxy concrete, which is used for structural repairs of concrete.
You should be able to get a good quality urethane / epoxy floor for about $10 per square foot, depending on the product you select and your location.
Urethane has a variety of uses including adhesives, sealants, electronic components, industrial filters and the restoration of wood.
Epoxy resin can be used as a jointing compound.
Urethane primers are not not compatible with gelcoat, nor are epoxy primers. Gelcoat can only be applied to bare fibreglass, existing (well sanded) gelcoat or polyester/vinylester based fillers.
urethane back in the day, most likely now the same urethane ***yes, it is still urethane
urethane comes from oil
Grout is cement, sand & a liquid, the liquid starts the process of the cement & sant setting from a powder to a solid. Traditionally it was WATER that was used as the liquid newer grouts substitute Epoxy as the liquid, making the grout set harder stick together better and resist stains