answersLogoWhite

0

what kind of job uses a headlamp?

User Avatar

Anonymous

12y ago
Updated: 8/20/2019

Mining, mechanics, HVAC technicians.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What kind of bulb for headlamp for a 2003 eclipse?

they are H4


Who here uses headlamp flashlight?

Anyone needing to have their hands free can benefit from using a headlamp flashlight. They are convenient when walking in the dark to a campsite when you have your hands full with camping equipment.


What type of headlamp bulb does a Toyota Aygo use?

The Aygo uses a H4 type of bulb


What kind of headlight bulb is in your 2005 Ford Expedition?

According to the 2005 Ford Expedition Owner Guide : Low beam headlamp ( # 9006 bulb ) High beam headlamp ( # 9005 bulb )


what kind of job is this ?

what job is this


How to change headlamp 99 Chevy Astro Van?

Remove the wiring harness from the back of your 1999 Chevy Astro headlamp. Remove the headlamp retaining bolts. The headlamp will come out. Reverse the process to install the new headlamp.


How do you change a headlamp 2002 buick rendezvous?

1. Open the hood.2. Remove the thumb screw from the back of the headlamp.3. Release the headlamp retainer by lifting up.4. Pull the headlamp straight forward, to release the ball stud from the grommet.5. Remove the headlamp from the upper fascia support.6. Disconnect the electrical connector from the headlamp.7. Remove the bulb(s) from the headlamp by rotating counterclockwise.8. Release the headlamp trim tabs from the headlamp, if required.9. Remove the headlamp trim from the headlamp, pulling to release the adhesive tape.10. Clean adhesive from the headlamp trim and headlamp using 3M™ adhesive remover P/N 8984, or equivalent.To install:1. Install new adhesive tape 3M® P/N 6382 or equivalent to the headlamp trim, if necessary.2. Position the headlamp trim to the headlamp, if removed.3. Install the headlamp trim to the headlamp, pressing until end tabs are fully seated.4. Install the headlamp bulb(s) to the headlamp by rotating clockwise.5. Connect the electrical connector to the headlamp.6. Position the headlamp to the upper fascia support.7. Press the headlamp into the upper fascia support until the ball stud is fully seated.8. Install the thumb screw to the rear of the headlamp.9. Engage the headlamp vertical retainer, by sliding downward until fully seated.10. Check the headlamp aim, if a new headlamp was installed, or if service or repairs in the front end area were made.11. Close the hood.


Where is the headlamp fuse on a 1985 Chevy pickup?

It doesn't have a headlamp fuse. They have a circuit breaker built into the headlamp switch.


How do you remove a headlamp on 1998 mercury tracer?

Open the hood to the engine compartment. Remove the headlamp wiring harness. Remove the headlamp assembly retaining bolts. The headlamp will come out.


How do i Replacing headlamp bulb rover 75?

In the wheel arch plastics there are removable inspection panels. Take these out to replace bulbs. Fiddly job.


Who uses mircroscope in their job?

scientist


What kind of products uses thiocyanate?

uses of thiocyanide