The Home Depot can send someone to give you a quote 1225 Wimberly Dr SW, Decatur, AL - (256) 353-2031
even with the tensioner loosened all the way i still cannot get the belt on. Any suggestions on how to get the belt on?
try changing plugs and wires then move to coils. if not there it could be and o2 sensor.
Try to check the valve cover gasket (most likely that's it) and the pan gasket.
Try changing the CRANK SHAFT Position Sensor.
A baby changing table is an excellent item to have in a baby's room. They are safe to use when you follow the manufacturers suggestions and stay close by, always being attentive to the baby. You should always use the safety strap. The standard size for baby changing tables is 17 inches by 35 inches.
Take the belt back off, then try to bolt the tensioner on.
To remove the bolt that attaches the lines to the block, I come in the front with a 3/8" drive 13mm swivel socket on a long extension. It helps if your on a lift.
Changing Filters monthly or bimonthly, Cleaning the Flame Sensor yearly or bi-yearly, and getting a yearly maintenance/tune-up from your dealer are good suggestions on how to maintain a furnace.
Could the odor be coming from the air vents?If so, changing the cabin filter might be helpful.See "Related Questions" below for more
did you check the water pump, alternator and anything else that might have a pulley?
Could be a number of things depending on how long ago the cooling system was serviced. Make sure the coolant level is correct this may be the most likely cause.
You first google: support at answers. Then you fill in the page with your problems, suggestions, comments, and concerns. (In this case, username changing.) They change your username in about a day. Your profile and contributions will not be lost.Contact support via the form available at this link: http://www.answers.com/page/contact_us