A trunk port is a port on a switch that can be assigned to carry multiple VLANs across switches or increase overall bandwidth/throughput.
Usually Port1 VLAN1 is deafult Trunk Port
a trunk port is called a trunk because it is part of the back end of a car - ie a trunk.
... an access port, which carries traffic only to and from the specific VLAN assigned to it. Contrast with 'trunk port' See http://searchnetworking.techtarget.com/definition/trunk
The idea of configuring a switch port as a trunk port is to allow the switch to receive and send data from several VLANs on a single port. Otherwise, a separate port would be required for every VLAN, if, for example, you want to connect two switches among themselves.The idea of configuring a switch port as a trunk port is to allow the switch to receive and send data from several VLANs on a single port. Otherwise, a separate port would be required for every VLAN, if, for example, you want to connect two switches among themselves.The idea of configuring a switch port as a trunk port is to allow the switch to receive and send data from several VLANs on a single port. Otherwise, a separate port would be required for every VLAN, if, for example, you want to connect two switches among themselves.The idea of configuring a switch port as a trunk port is to allow the switch to receive and send data from several VLANs on a single port. Otherwise, a separate port would be required for every VLAN, if, for example, you want to connect two switches among themselves.
in the trunk near the battery
since the first desire of desirable mode is to trunk,so the switch port mode will be trunking since the first desire of desirable mode is to trunk,so the switch port mode will be trunking
native vlan
The frames are assigned to the native VLAN.
Port Fast is used to bring an interface used as an access or trunk port to a forwarding state from a blocked state.
To turn off Dynamic Trunking Protocol (DTP) on a trunk link between switches, you can use the command switchport mode trunk followed by switchport nonegotiate on the interface. This configuration disables DTP negotiation, forcing the port to remain in trunk mode without attempting to negotiate with the other end. Alternatively, you can set the switchport to access mode using switchport mode access, which effectively disables trunking on that port.
There is a recharging port down and to the left of the steering wheel, next to the trunk release button. Insert the back end of the fob into the port and it will lock in place.
A Port VLAN ID (pvid) is a default VLAN ID that is assigned to an access port to designate the virtual LAN segment to which this port is connected. The pvid places the port into the set of ports that are connected under the designated VLAN ID. Also, if a trunk port has not been configured with any VLAN memberships, the virtual switch's Port VLAN ID (pvid) becomes the default VLAN ID for the ports connection.