0
To replace the broken rear door hinge on a 1986 GMC Vandura, start by removing any interior panels or covers to access the hinge area. Support the door while removing the old hinge bolts using the appropriate tools. Install the new hinge by aligning it with the door and body, then securely fasten the bolts. Finally, reattach any interior panels and test the door's functionality.
What else can I help you with?
How do you get the hing pins out of the backdoor of a 1986 Chevy astro van?
Not removable- replace entire hinge assembly
How do you change door hinge pins and bushings on a 1986 Chevy half ton pickup?
I would recommend you replace the entire hinge and forget about repairing it. In my experience this is the best route to take.
1986 gmc vandura 2500 curb weight?
3254
Will the wheels from a Chevy S10 pickup fit a 1986 gmc vandura van?
No.
When was John Hings born?
John Hinge was born in 1986.
What size engine in a 1986 gmc 2500 vandura with a 5.0 liter?
5 liter is the engine size. In non-metric its 305cid
What are the release dates for Centurions - 1986 Broken Beams 1-30?
Centurions - 1986 Broken Beams 1-30 was released on: USA: 24 October 1986
Replace water pump for 1986 Chevy Nova?
Replace water pump for an 1986 Chevy Nova?
What are the release dates for Pingu - 1986 Pingu and the Broken Vase?
Pingu - 1986 Pingu and the Broken Vase was released on: USA: 19 October 2001
How do you replace the starter 1986 El Camino?
how to replace a starter
What are the release dates for Talk2DIY Automotive - 1986 Oxidation and Broken Fender?
Talk2DIY Automotive - 1986 Oxidation and Broken Fender was released on: USA: 19 August 2004
How do you adjust the drivers door on a 1986 Chevy Celebrity?
The adjustments are preset at the factory. If the door is sagging it may need new hinge pins and bushings. IF you have changed doors and the hinge pins and bushings are good the adjustments are on the door post behind the dash or the kick panel on the bottom. The hinges are commonly tack welded in place and the welds have to be broken. It is a royal pain in the neck to get to the adjustments. If you have a factory service manual or a Chilton or Haynes manual you will find better help there. GOOD LUCK
