Power and ground
I'm Guessing that your talking about the A/C compressor, in which there are 1 or 2 wires going to the clutch. Disconnecting this wire(or 2) will disable the compressor clutch stopping the compressor from working.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
TAke the Air cleaner off. If it is injected there will be wires in the top of the throttle body. If not there will be no wires visible. By 1989 all of Dodge Ram gas engines were fuel injected.
Sungwon Compressor was created in 1989.
You can find repair manuals at almost any auto parts store that will show you the wiring diagrams of your vehicle.
can you please provide ma a spark plug wiring diagram for a 1989 ford bronco v6 so i can print it i beleive my wires are on wrong
You Either have a Broken wire or a bad connecion from your wiring harness to your ECU Recommend removing plug and testing wires for continuity and or voltage also check harness connection
I wanted to put a new receiver in but i need the speaker wires to be plugged into the wiring harness and i cannot find them. i can find them by the speakers, but the do not go to the receiver...why is this? and where are they
I have a 1989 Dodge B250...it has overdrive
http://www.commandocaralarms.com/wiring/1989/Nissan/Pulsar
Now days it is not feesable to replace just the clutch on the a/c. Just as cheap to buy a compressor and vaccum and have it serviced right. Older methods are just gone due to the crappy economy and cheaper parts..
I have a 1987 Dodge D100 318 and the fuel pump was at the front of the engine underneath where the air compressor/a'c pump is at. looking at the front of the truck it is on the lower left side almost directly behind radiator The 1989 should be fuel injected which will mean the pump is in the tank.